Bush Hog® Heavy Duty Subsoilers

(HDSS1S and HDSS1L Series)

The new 3-point heavy duty subsoilers from Bush Hog® are the right tool for you when breaking up a hardpan developed over years of heavy use. Compacted soil can hurt you in two ways: plant roots cannot penetrate into the lower levels of the soil to tap additional nutrients and, in wet conditions, the excess water cannot drain away…both effects weaken your plants and reduce your yields. The new HDSS model subsoilers from Bush Hog® are available in four configurations, single or double shank with either short or long shank, capable of ripping the soil to depths ranging from 19 inches to 23 inches depending on the shank length. In certain areas, these subsoilers can be used to install water lines at depths suitable to get below the frost line. The beveled edge of the high carbon steel shank, combined with a heat-treated replaceable plow point, allow you to cut through the soil with minimal ground disturbance; shear pin protection is provided. When you need to go deep…the Bush Hog® HDSS subsoilers get the job done for you. Nothing beats a Bush Hog®!

FullSize_DSS1S
Notes: Unit(s) shown equipped with certain selections and options; please consult with your local Bush Hog dealer for all available configurations.

Performance Features

  • Cat. 1/2 Quick Hitch
  • Replaceable Bolted on Cutting Point
  • Depths ranging from 19 inches to 23 inches depending on the shank length.
  • Available in Major Tractor Colors

Product Features

BHSubSoilerHDD1SInsert1

Replaceable
Heat-Treated
Cutting Tip

BH Sub Soiler HDD1S Insert 2

Beveled Shanks
/Promote Easier
Ground Penetration

 

BH Sub Soiler HDD2S Insert 3

Parking Stands are Standard

Good for Tractors rated 40hp or under

HDSS1S
HDSS1L

Specifications

Models
HDSS1S
HDSS1L
Description
Subsoiler Heavy Duty 1 Shank Short
Subsoiler Heavy Duty 1 Shank Long
Hitch
Cat. 1/2 Quick Hitch
Max Depth
19
Overall Width
41
Overall Height
39 1/2
43 1/2
Engine Horsepower
Approximately 35 hp per shank up to 85 hp
Weight
261-lbs.
Shank Size
1 1/4” x 9 7/16” x 26 1/8”
Number of Shanks
1
Cutting Point
1” x 2 1/2” x 9 3/8”, Replaceable, Bolted On

 

Available in Major Tractor Colors

Videos

 

 

Privacy Preference Center