Bush Hog’s new DSP Line of Pull-Type Drag Scrapers, with standard fixed axle or optional tilt axle, is ideal for moving large quantities of material, leveling, and finish grading. The DSP units come available in 8’, 10’ and 12’ widths. DSP scrapers equipped with the optional tilt axle can do everything the standard axle does, as well as remove material on an angle for sloping, terracing and ditching. Material can be transferred by dragging it to nearby locations and raising the scraper to deposit the load. Surfaces can be graded and leveled by scraping material from high areas and allowing accumulated material to flow under the grader blade into lower areas. The DSP scrapers are designed for 70 to 125 horsepower tractors and have replaceable wear plates on the sides.
Place your mouse over the image to enlarge any portion of the product below.
NOTE: Unit(s) shown equipped with certain selections and options; please consult with your local Bush Hog dealer for all available configurations.
- Available in 8-feet and 10-feet widths.
- Optional tilt axle removes material on an angle for sloping, terracing and ditching.
- DSP scrapers are designed for 70 to 125 horsepower tractors
- Replaceable wear plates on the sides.
|Horsepower Rating||70 to 125||70 to 125|
|Working Width||96 3/16-inches||120 3/16-inches|
|Capacity||1 3/4 cu. yds.||2 1/4 cu. yds.|
|Weight without material in Weight Box|
|No Tilt Axle||1405-lb||1525-lb|
|Weight of Material in Weight Box||760-lb||760-lb|
|Depth of Box||39-inches||39-inches|
|Maximum Cutting Depth||5-inches below grade||5-inches below grade|
|Maximum Tilt Depth To the Right||7-inches||7 5/8-inches|
|Maximum Tilt angle||3 1/2°||3 1/2°|
|Tongue Construction||4-inches x 4-inches x 1/4-inch tubing||4-inches x 4-inches x 1/4-inch tubing|
|Side Plate Construction||3/8-inch x 24 5/16-inches high x 39 3/4inches deep||3/8-inch x 24 5/16-inches high x 39 3/4inches deep|
|Moldboard Construction||1/4-inch x 24 1/4-inches high when formed||1/4-inch x 24 1/4-inches high when formed|
|Cutting Edge||1/2-inch x 6-inches reversible & replaceable||1/2-inch x 6-inches reversible & replaceable|
|Cutting Edge Reinforcement||3-inches x 3-inches x 5/16-inch angle plus a 1/4-inch mold board = 9/16-inch at the cutting edge.|
|Tires||New 9.5l x 15 8 PLY RIB TL on Rim 5 with 5.5 BHC||New 9.5l x 15 8 PLY RIB TL on Rim 5 with 5.5 BHC|
|Maximum Transport Speed||20 MPH||20 MPH|
|Lift Cylinder||3 1/2-inches x 8-inches ASAE||3 1/2-inches x 8-inches ASAE|
|Tilt Cylinder||3 1/2-inches x 8-inches ASAE||3 1/2-inches x 8-inches ASAE|